TSI E-Lock

YOU WILL NEED:

9-volt alkaline battery (Duracell®, Energizer®)

Step 1 – Remove Keypad Housing

Press and hold the small release button located on the bottom of the keypad housing. While holding the button, rotate the keypad housing counterclockwise (left) and carefully remove it from the keypad base to access the battery connection.

Step 2 – Connect the Battery

Connect a new 9-volt alkaline battery to the 9-volt battery connector. Ensure the positive (+) and negative (–) terminals are properly aligned before gently pressing the battery into place.

Step 3 – Reinstall the Keypad Housing

Carefully place the battery and components back inside the keypad housing. Position the keypad housing onto the keypad base.

Step 4 – Secure the Keypad Housing

Rotate the keypad housing approximately 30° clockwise (right) until it locks into place and returns to its original upright position.

*Please Note: After installing a new battery, wait 5 minutes before using the lock. The electronic lock may emit a series of beeps during startup. This is normal and will stop once initialization is complete.