You Will Need:
- 9-volt alkaline battery (Duracell®, Energizer®)
- Phillips head screwdriver
Step 1 – Open Slide Door
Open the Slide door located on the bottom of the keypad.
Step 2 – Remove Old Battery
Gently pull the battery connector and wires down.
Step 3 – Connect New Battery
Attach the new battery (9-volt alkaline only) to the connector.
Be careful not to pull on the wires.
Step 4 – Reinsert Battery
Carefully insert the battery back into the keypad until the wires are no longer exposed and slide the door closed.
FACTORY SET COMBINATION: 1 – 2 – 3 – 4 – 5 – 6
IMPORTANT: ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN AND BOLTS EXTENDED.
Enter zero (0) six times. (You will hear a double beep, indicating program mode).
Enter your existing six (6) digit combination one time. (You will hear a double beep)
Enter your NEW six (6) digit combination. (You will hear a double beep)
Enter your new six (6) digit combination again.
Wait approximately 10 seconds and then enter your new combination, and then rotate the handle to open the safe door.
Test lock operation several times before closing the door.