S&G Lock

Watch Video

Red light located next to #1 button
*DO NOT REMOVE KEYPAD FROM THE DOOR

Battery Installation

You Will Need:

    9-volt alkaline battery (Duracell®, Energizer®)

Step 1 – Open Slide Door

Open the Slide door located on the bottom of the keypad.

Step 2 – Remove Old Battery

Gently pull the battery connector and wires down.

Step 3 – Connect New Battery

Attach the new battery (9-volt alkaline only) to the connector.

Be careful not to pull on the wires.

Step 4 – Reinsert Battery

Carefully insert the battery back into the keypad until the wires are no longer exposed and slide the door closed.

Lock Instructions

FACTORY SET COMBINATION: 1 – 2 – 3 – 4 – 5 – 6

We recommend that you change your combination before you begin using your new gun safe. It is a simple process but must be executed exactly.

First, select a six (6) digit combination that you can easily remember and then follow the instructions below:

Step 1

Enter your existing combination and open the door. Once open, extend the locking bolts completely so that the door remains open.

THE DOOR SHOULD ALWAYS BE OPEN WHEN YOU ARE CHANGING COMBINATIONS.

Step 2

Enter in six (6) zeroes to enter programming mode. (You will hear a double beep).

Step 3

Enter your existing six (6) digit combination. (You will hear a double beep).

If you do not hear a double beep, leave the door open and start over at step 2.

Step 4

Enter your newly selected six (6) digit combination. (You will hear a double beep).

If you do not hear a double beep, leave the door open and start over at step 2.

Step 5

Enter the new combination again to confirm your selection. If done correctly, you will hear a double beep.

If you do not hear a double beep, leave the door open and start over at step 2.

Wait ten seconds before moving on to the next step to allow your combination to permanently set.

Troubleshooting

Not Opening
If the door will not open or makes several beeps after entering your code, it may be time to change batteries.

2 Beeps
If you enter your code and hear two (2) beeps and no motor sound, please change battery.

3 Beeps
If you enter your code and hear three (3) beeps. Please download the combination request form.