TS19
Battery Installation
Step 1
Remove the Key Pad Housing – while depressing the small button located on the bottom on the key pad housing, rotate the keypad counter- clockwise (left) and remove the key pad housing to access the battery connection.
Step 2
Connect the 9V Alkaline battery, gently insert the battery inside the key pad housing.
Step 3
Put the cover back on the keypad base.
Step 4
Rotate the cover clockwise (right) 30° until it is back to the original upright position.
Lock Instructions
FACTORY SET COMBINATION: 1 – 2 – 3 – 4 – 5 – 6
IMPORTANT: ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN AND BOLTS EXTENDED.
Step 1
Enter zero (0) six times. (You will hear a double beep, indicating program mode).
Step 2
Enter your existing six (6) digit combination one time. (You will hear a double beep)
Step 3
Enter your NEW six (6) digit combination. (You will hear a double beep)
Step 4
Enter your new six (6) digit combination again.
Step 5
Wait approximately 10 seconds and then enter your new combination, and then rotate the handle to open the safe door.
Step 6
Test lock operation several times before closing the door.