TS26

Battery Installation

Step 1

Remove the Key Pad Housing – while depressing the small button located on the bottom on the key pad housing, rotate the keypad counter- clockwise (left) and remove the key pad housing to access the battery connection.

Step 2

Connect the 9V Alkaline battery, gently insert the battery inside the key pad housing.

Step 3

Put the cover back on the keypad base.

Step 4

Rotate the cover clockwise (right) 30° until it is back to the original upright position.

Lock Instructions

FACTORY SET COMBINATION: 1 – 2 – 3 – 4 – 5 – 6

IMPORTANT: ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN AND BOLTS EXTENDED.

Step 1

Enter zero (0) six times. (You will hear a double beep, indicating program mode).

Step 2

Enter your existing six (6) digit combination one time. (You will hear a double beep)

Step 3

Enter your NEW six (6) digit combination. (You will hear a double beep)

Step 4

Enter your new six (6) digit combination again.

Step 5

Wait approximately 10 seconds and then enter your new combination, and then rotate the handle to open the safe door.

Step 6

Test lock operation several times before closing the door.